Finish bodywork on canopy, Apply acid etch primer, epoxy sanding primer, base coat white , top coat red
Finish bodywork on canopy, Apply acid etch primer, epoxy sanding primer, base coat white , top coat red
fabricate and assemble rear spinner plate
fabricate and assemble rear spinner plate
Fitting and installation of horizontal and vertical stabilizer fairings
Fitting and installation of horizontal and vertical stabilizer fairings
After trimming to the scribe lines and attaching in place I wasn't really happy with the fit where the fiberglass faring intersects with the horizontal stab. There was about 1/8 inch gap at the leading edge . I molded the faring to the stab with epoxy / cotton flox , this will be feathered before I paint and will give a nice glove fit.
No comments:
Post a Comment